Description
ECO Farm smart light controller is a dual-channel smart controller which gives growers the ability to control up to 50 fixtures per room or 100 total lights with a single controller. It has two dedicated temperature sensors, one for each room that provides real-time data for automated temperature-based dimming, as well as a high-temperature shutdown feature that protects your garden.
Installing the controller is very simple. All you need to do is plug the power cable into the wall outlet, connect the RJ cables from the controller to each LED/HPS light, and connect the temperature sensors. From there all you havew to do is set your wattage, on/off times, high temp shutoff and dimming points and yoiu are ready to start growing!
- No need for a switchboard
- Easy and safe installation(low voltage device)
- Dual channel module
- Sunrise &sunset
- Protected against short circuit
- Double temperature safety feature
- Control up to 100 ballasts/light
- Show output as W or %
- Auto shutdown at temperature setting
- APP Smart control of ballast and LED light
1. Press 
to turn on/off the LED fixtures.
Main interface with ENVIRONMENT TEMPERATURE (TEM) /LOCAL TIME (T) /BRIGHTNESS(CHA-Channel A)
2. Please set local time first before using dimming function: press"TIME" for local time setting.
3. Customization settings: The dimmer can set/save 2 customized settings in the system.
Step 1: Press "CUS" to enter into customization settings(INTERFACE 3).
Step 2: Press "OK" to select,press for CUSTOM 1/CUSTOM 2 toggle
Step 3: Press "OK" to select CUSTOM1 or CUSTOM2,press"OK" again to enter into setting interface(INTERFACE 4)
Step 4: Press "OK" to start setting,press directional key UP/DOWN/LEFT/RIGHT to select BRT(BRIGHTNESS) and TIME(INTERFACE 4).press " + - " to change the number.
Step 5: When all customization setting done,press "OK" to save and auto run the "CUSTOM" settings(INTERFACE 5)
Caution: Assume that SET1 start time is 06:00, the SET2 start time should be after 06:00 like 06:01 and can not be 06:00 which is same with SET1,if set the same time,the system will be confused at 06:00 and can not run normally at this time.
4. Press "PRE" to select factory preset programs, there are 2 preset programs in the system,press the directional key "UP/DOWN to select "PRESET1" or "PRESET2",once selected,press "OK" to save and run the program.
Note: Press "Back" can cancel the Preset setting and back to the main interface.
